The Siemens 6ES7288-5DT04-0AA0 is a SIMATIC S7-200 SMART SB DT04 Digital I/O Signal Board that provides two digital inputs plus two 0.75 A transistor outputs on a compact signal board.
- SB DT04
- 2 digital inputs and 2 transistor outputs, 24 V DC
- 24 V DC; 20.4 to 28.8 V DC
- 35 x 52.2 x 16 mm
In an S7-200 SMART automation station, it adds two 24 V DC digital inputs and two fast 24 V DC transistor outputs to a compatible CPU signal-board slot. It works with the exact CPU, expansion-bus or signal-board interface, wiring, field devices, and project configuration specified for the complete article number. It is applied in small interlocks, local sensors, indicators, solenoids, and machine-option I/O.
Important Notice: Use the complete 6ES7288-5DT04-0AA0 code and verify the physical nameplate, current Siemens documentation, signal range, wiring, project, and accessories before installation or replacement.
Apter Power 6ES7288-5DT04-0AA0 Manuals and Guides
Important Notice: These are two separate Apter Power documents prepared from the manufacturer-published Siemens information named in each document. Confirm the physical nameplate, current Siemens documents, and host-system requirements before installation or replacement.
Machine-option I/O
Adds two input states and two fast transistor commands without a full-width module
Local sensor acquisition
Reads compatible 24 V DC switches and sensors
Fast actuator command
Drives compatible 24 V DC electronic loads within channel limits
Compact CPU expansion
Supports small interlocks, local sensors, indicators, solenoids, and machine-option I/O
Read the exact Siemens S7-200 SMART documentation before use. Verify 6ES7288-5DT04-0AA0, SB DT04, host system, signal type, wiring, and project from the physical installation.
1
Identity: Match every character of 6ES7288-5DT04-0AA0 and the SB DT04 marking to the physical nameplate and project
2
Host and power: Verify 24 V DC; 20.4 to 28.8 V DC; isolate all energy sources before insertion, removal, or wiring
3
Digital I/O: Verify input commons, output polarity, 0.75 A channel rating, group current, load suppression, and absence of output short-circuit protection
4
Cabling: Follow Siemens terminal, shielding, grounding, separation, and maximum cable-length instructions
5
Commissioning: Verify addresses and scaling, energize one circuit group at a time, test fail-safe behavior, and record results
Videos
News
Applications
