The 330171-00-08-20-02-00 is a Bently Nevada 3300 5 mm non-contacting eddy-current proximity probe with 1/4-28 UNF mounting threads, no armor, 0.0 in unthreaded length, a 0.8 in overall case, a 2.0 m (6.6 ft) standard cable, and a ClickLoc connector without protector. The final 00 code selects no agency approval option.
- 1/4-28 UNF
- 0.0 in
- 0.8 in
- 2.0 m (6.6 ft)
Used with a correctly matched 3300 XL extension cable and 3300 XL Proximitor Sensor, it converts distance from the compact 5.2 mm probe tip to a conductive shaft or target into a proportional voltage. The complete system measures dynamic radial vibration, static or axial position, Keyphasor phase reference, and rotational speed on fluid-film-bearing machinery. For dependable operation, follow the official system-matching, mounting, wiring, environmental, and approval instructions.
Important Notice: Verify 1/4-28 engagement, 0.8 in reach, 2.0 m (6.6 ft) matched-system cabling, final gap, target geometry, and the 00 approval evidence before commissioning.
Apter Power 330171-00-08-20-02-00 Manuals and Guides
Important Notice: These are two separate Apter Power documents prepared from the official Bently Nevada source named in each document. Confirm the physical nameplate, current manufacturer documentation, and applicable installation drawing before installation or replacement.
Thrust Bearing Pads
The compact 5.2 mm tip supports constrained mounting between bearing pads.
Fluid-Film Bearings
Measures radial shaft vibration relative to the probe location.
Axial Position
Measures thrust movement against a conductive target.
Keyphasor Reference
Provides a phase-reference signal from suitable target geometry.
Speed Measurement
Supports rotational-speed channels within manufacturer application limits.
General Industrial Machinery
Supports non-approved installations when option 00 is appropriate.
Read and follow the official manufacturer source and applicable installation instructions before use. Verify the exact complete ordering code from the physical nameplate.
1
Match the 2.0 m probe with a 3.0 m 330130 extension cable and 5.0 m 330180 Proximitor Sensor, or with a 7.0 m extension cable and 9.0 m sensor.
2
Limit 1/4-28 engagement to 0.375 in and follow the 5.1 N m recommended case torque.
3
Maintain the 25.4 mm minimum bend radius and protect the ClickLoc connection from oil, moisture, crushing, and sharp edges.
4
Set the final gap against the actual target and verify target size, shaft diameter, probe spacing, and monitoring scale.
5
Do not infer hazardous-area approval; final option 00 does not request an approval configuration.
Videos
News
Applications
