PM902F-3BDH001000R0005 is an ABB standard CPU module for the Freelance AC 900F controller family. ABB documentation identifies this R0005 hardware revision and describes PM 902F as the standard controller CPU with four Ethernet interfaces, two serial interfaces, a diagnostic interface, SD-card support, and two communication-interface slots.
- ABB
- Freelance AC 900F
- 800 MHz
- 24 MB
The CPU executes the Freelance control application, coordinates direct and remote I/O, processes controller communications, and can operate in a single or redundant controller arrangement for process automation systems.
Important Notice: Use the complete PM902F-3BDH001000R0005 code and verify the physical nameplate and current ABB documentation before installation or replacement.
Apter Power PM902F-3BDH001000R0005 Manuals and Guides
Important Notice: These are two separate Apter Power documents with distinct layouts and model-specific content, prepared from the manufacturer-published ABB information named in each document. Confirm the physical nameplate, current manufacturer documents, and host-system requirements before installation or replacement.
ABB Freelance AC 900F DCS
Maintains the documented controller execution, redundancy, and project backup role in a correctly matched installation.
Process and machine automation
Supports the control, communication, power, safety, measurement, or protection duty stated in the official source for this exact or verified family identity.
Lifecycle-controlled maintenance
Requires complete-code, nameplate, host-system, and project verification before replacement or recommissioning.
Read and follow the exact ABB documentation and host-equipment instructions before use. Verify PM902F-3BDH001000R0005 from the physical nameplate.
Check 1
Match every character of PM902F-3BDH001000R0005 to the physical nameplate before work.
Check 2
Use the exact ABB manual, wiring drawing, and safety instructions for the installed revision.
Check 3
De-energize and apply the required lockout, discharge, ESD, and stored-energy controls before removal.
Check 4
Back up firmware, parameters, controller project, calibration, and network settings where applicable.
Check 5
Verify supply, signal type, polarity, grounding, shielding, connector pinout, load, and environmental limits.
Check 6
Commission with the manufacturer test procedure and record results before returning equipment to service.
Videos
News
Applications