CI545V01 3BSE011063R1 is an ABB Advant Master communication-interface identifier. ABB's official AC 450 parts material identifies CI545V01 as the AccuRay 1190 Ethernet interface and lists the related official product identifier 3BUP001191R1; the requested 3BSE011063R1 marking must therefore be reconciled with the physical label before installation.
- ABB
- CI545V01
- AccuRay 1190 Ethernet interface
- Advant Master AC 450
In the documented Advant Master application, the interface exchanges Ethernet communication data between the AC 450 environment and an AccuRay 1190 system, with network addressing, cabling, firmware, and project mapping governed by the original installation records.
Important Notice: Use the complete CI545V01 3BSE011063R1 code and verify the physical nameplate and current ABB documentation before installation or replacement.
Apter Power CI545V01 3BSE011063R1 Manuals and Guides
Important Notice: These are two separate Apter Power documents with distinct layouts and model-specific content, prepared from the manufacturer-published ABB information named in each document. Confirm the physical nameplate, current manufacturer documents, and host-system requirements before installation or replacement.
ABB Advant Master AC 450
Maintains the documented AccuRay Ethernet integration and article-number reconciliation role in a correctly matched installation.
Process and machine automation
Supports the control, communication, power, safety, measurement, or protection duty stated in the official source for this exact or verified family identity.
Lifecycle-controlled maintenance
Requires complete-code, nameplate, host-system, and project verification before replacement or recommissioning.
Read and follow the exact ABB documentation and host-equipment instructions before use. Verify CI545V01 3BSE011063R1 from the physical nameplate.
Check 1
Match every character of CI545V01 3BSE011063R1 to the physical nameplate before work.
Check 2
Use the exact ABB manual, wiring drawing, and safety instructions for the installed revision.
Check 3
De-energize and apply the required lockout, discharge, ESD, and stored-energy controls before removal.
Check 4
Back up firmware, parameters, controller project, calibration, and network settings where applicable.
Check 5
Verify supply, signal type, polarity, grounding, shielding, connector pinout, load, and environmental limits.
Check 6
Commission with the manufacturer test procedure and record results before returning equipment to service.
Videos
News
Applications