3BSE007137R1-PFVO131 is a complete ABB legacy module marking. ABB currently publishes documentation for later PFEA and PFVA force-measurement electronics, but the reviewed public sources do not define the exact PFVO131 article, so its signal ranges, load-cell interface, and output functions are not inferred.
- ABB
- 3BSE007137R1-PFVO131
- Not confirmed in reviewed ABB public documents
- Verify from the exact PFVO131 manual
Use the physical label and the original force-measurement system drawings to identify the connected sensors, excitation, signal outputs, supply, calibration data, and mechanical application before any replacement or test.
Important Notice: Use the complete 3BSE007137R1-PFVO131 code and verify the physical nameplate and current ABB documentation before installation or replacement.
Apter Power 3BSE007137R1-PFVO131 Manuals and Guides
Important Notice: These are two separate Apter Power documents with distinct layouts and model-specific content, prepared from the manufacturer-published ABB information named in each document. Confirm the physical nameplate, current manufacturer documents, and host-system requirements before installation or replacement.
ABB legacy force-measurement hardware
Maintains the documented sensor excitation, calibration, and exact legacy identity role in a correctly matched installation.
Process and machine automation
Supports the control, communication, power, safety, measurement, or protection duty stated in the official source for this exact or verified family identity.
Lifecycle-controlled maintenance
Requires complete-code, nameplate, host-system, and project verification before replacement or recommissioning.
Read and follow the exact ABB documentation and host-equipment instructions before use. Verify 3BSE007137R1-PFVO131 from the physical nameplate.
Check 1
Match every character of 3BSE007137R1-PFVO131 to the physical nameplate before work.
Check 2
Use the exact ABB manual, wiring drawing, and safety instructions for the installed revision.
Check 3
De-energize and apply the required lockout, discharge, ESD, and stored-energy controls before removal.
Check 4
Back up firmware, parameters, controller project, calibration, and network settings where applicable.
Check 5
Verify supply, signal type, polarity, grounding, shielding, connector pinout, load, and environmental limits.
Check 6
Commission with the manufacturer test procedure and record results before returning equipment to service.
Videos
News
Applications