ABB 1SAP121000R0001 PM564-RP is a 24 V DC AC500-eCo processor module for compact industrial automation control. It executes the PLC application and connects mixed onboard digital and analog field signals.
- 128 kB Flash EPROM program memory
- 6 digital inputs and 6 relay outputs
- 2 analog inputs and 1 analog output
- RS-485 COM1 and I/O-bus expansion for up to 10 I/O modules
The PM564-RP reads discrete and analog input channels, processes the configured control program, and commands relay and analog output channels. COM1 can serve as a programming port, Modbus master or slave, serial ASCII interface, or CS31 master. ABB lists the MC503 memory card, TA561-RTC, TA562-RS, TA569-RS-ISO and TA562-RS-RTC as usable accessories; select accessories and field wiring according to current ABB documentation and the installed system configuration.
Important Notice: Terminal blocks, memory card, real-time clock, serial option modules, manuals, software and other accessories are not included unless specifically stated in the quotation or stock description.
Apter Power 1SAP121000R0001 PM564-RP Manuals and Guides
Important Notice: These are two separate Apter Power documents independently prepared from manufacturer-published ABB information. Confirm the physical nameplate, current ABB documents, and host-system requirements before configuration or installation. They do not replace official ABB manuals.
Compact machine control
Executes cyclic, time-controlled and multitasking PLC logic with onboard mixed I/O
Mixed field-signal processing
Reads six digital and two analog inputs; controls six relay outputs and one analog output
Modbus and serial integration
Uses COM1 for programming, Modbus master or slave, serial ASCII, or CS31 master communication
Expandable I/O control
Connects up to 10 additional I/O modules through the I/O bus
Read and follow the exact ABB documentation and control-panel instructions before use. Verify 1SAP121000R0001 PM564-RP from the physical nameplate.
1
Power supply: Use 24 V DC within -15% to +20% from the ABB-specified extra-low-voltage source types
2
Temperature: 0 to +60 °C horizontally; 0 to +40 °C vertically with output load reduced to 50% per group
3
Enclosure: IP20 applies only when all terminal screws are tightened; install inside a suitable control cabinet
4
Mounting: Use 35 mm DIN rail or 4 mm mounting screws; ABB specifies a fastening torque of 1.2 Nm
5
COM1 and commissioning: Keep the non-isolated RS-485 common-mode range within -8 V to +12 V and confirm wiring, loads, accessories, firmware, and project compatibility
Videos
News
Applications
