ABB IMASO11 is a Harmony rack analog output module with 14 independently configurable output channels. Its official instruction identifies two output modes, 4-20 mA current and 1-5 VDC voltage, for transferring controller commands to compatible field receiving devices.
- Analog outputs: 14
- Current output: 4-20 mA
- Voltage output: 1-5 VDC
- Conversion resolution: 10-bit
ABB documents 10-bit output conversion, output readback, and configurable output default-state behavior. The instruction specifies accuracy of no more than 0.15 percent for voltage output and no more than 0.25 percent for current output, with a maximum 750-ohm current-loop load and a minimum 22-kilohm voltage load for the exact IMASO11 model. The instruction associates IMASO11 with NTDI01 and NIDI01 termination arrangements, and ABB rack termination data also identifies NTBMA2 for 14 system-powered analog outputs with IMASO11. ABB's NTDI02 instruction describes NTDI02 as a functional replacement for NTDI01, not a direct replacement, so the exact installed topology and wiring must be reviewed. ABB evolution material maps the ASO01/ASO11 function toward AO02e and separately shows a Symphony Plus ASO11 successor spelling. These references establish migration paths, not identical hardware. IMASO11 therefore remains a separate canonical product, while lifecycle phase, origin, customs code, weight, and dimensions remain HOLD.
Important Notice: Verify the complete ABB IMASO11 nameplate and current project documentation before use.
Apter Power IMASO11 Manuals and Guides
Important Notice: The first link is the model-specific product-parameters PDF prepared only from the cited ABB official evidence; the second link is the Apter Power product information manual. Confirm the physical nameplate, current ABB documents, and host-system requirements before installation or replacement.
Control-valve current commandSend a configured 4-20 mA command to a compatible receiving device when the project loop design meets the documented load limit.
Drive or position referenceProvide a supported current or 1-5 VDC reference to engineered drive, positioner, or converter inputs after interface review.
Recorder and remote-indicator outputsTransmit supported analog values to compatible high-impedance receiving equipment under the documented voltage-load requirement.
ASO11 modernization planningUse ABB's SPASO11/AO02e evolution relationships as engineering inputs for a controlled rack I/O migration.
Read and follow the exact ABB documentation and host-equipment instructions before work. Verify the complete physical nameplate and system configuration.
1Verify exact IMASO11 identity, assembly revision, rack slot, and configured output mode before work.
2Back up function codes, ranges, scaling, default-state selections, alarm logic, and controller configuration.
3Confirm NTDI01, NIDI01, or NTBMA2 topology and its exact cable and terminal assignments from ABB and site drawings.
4Respect the documented 750-ohm maximum current-loop load and 22-kilohm minimum voltage-load requirement for IMASO11.
5Review safe output states and process consequences before removal, insertion, download, or controller restart.
6Use ABB electrostatic-discharge controls and approved powered-rack service procedures; online replacement capability does not remove process hazards.
7Perform output simulation, polarity, scaling, readback, and end-device response checks under authorized process conditions.
8Do not treat NTDI02 as a direct NTDI01 replacement or SPASO11/AO02e as the same order code.
9Do not publish formal lifecycle, origin, HS code, weight, or dimensions without exact ABB model-level evidence.
Videos
News
Applications
