ABB SPDSO14 is a Symphony Plus HR Series digital output module with up to 16 optically isolated open-collector outputs. ABB documents 24 VDC operation at up to 250 mA per stated output rating and 48 VDC operation at up to 125 mA.
- Outputs: Up to 16 open-collector digital outputs
- Isolation: Optically isolated
- 24 VDC rating: 250 mA
- 48 VDC rating: 125 mA
The module supplies discrete commands to field circuits such as annunciation, permissive, interposing-relay, and on/off control circuits. Open-collector behavior, field supply, polarity, load type, and protective devices must be engineered as a complete circuit. ABB lists direct use with NTDO02 solid-state relays or with a relay assembly using electromechanical relays. NTDO02 can provide up to eight solid-state relay outputs, and ABB states that each of the module's 16 output signals can drive up to nine relays through NTDO02. ABB maps the older IMDSO14 to SPDSO14 in its Harmony evolution material. The mapping is not permission to transfer wiring blindly: the installed terminal unit, dipshunt, polarity, field voltage, relay population, control logic, and diagnostics must all be checked.
Important Notice: Confirm SPDSO14 rather than IMDSO14, SPDSO04, or a mixed-input/output DSM module.
Apter Power SPDSO14 Manuals and Guides
Important Notice: The first link is the product-parameters PDF prepared only from the cited manufacturer information; the second link is the Apter Power product manual. Confirm the physical nameplate, current manufacturer documents, and host-system requirements before installation or replacement.
Discrete actuator command
Operates compatible 24 VDC or 48 VDC on/off circuits within the documented current rating.
Interposing-relay control
Drives ABB-documented solid-state or electromechanical relay arrangements for galvanically separated field loads.
Alarm and annunciation
Provides controller-commanded discrete outputs to compatible indication and annunciation circuits.
IMDSO14 modernization
Supports an engineered move from IMDSO14 after wiring, polarity, termination, and logic verification.
Read and follow the current ABB documentation and host-equipment instructions before work. Verify the complete physical nameplate and system configuration.
1
Back up the controller database, output logic, fail states, and channel assignments before service.
2
Verify whether the field circuit is 24 VDC or 48 VDC and stay within the documented current rating.
3
Confirm open-collector polarity, commons, field supply, fusing, suppression, and load type from approved drawings.
4
Verify the exact termination unit, relay assembly, cable, dipshunt, slot, and address; family compatibility is not a wiring instruction.
5
Follow ABB and site isolation, ESD, insertion/removal, and commissioning procedures.
Videos
News
Applications
