Schneider Electric LC1D32F7C is a TeSys Deca three-pole IEC contactor configuration using the authorized LC1D32F7 technical record. It is rated for 32 A AC-3 operation with a 110 V AC 50/60 Hz coil.
- Three-pole IEC contactor with three normally open main contacts
- 32 A AC-3 motor-control rating
- 110 V AC 50/60 Hz coil configuration
- 15 kW AC-3 motor power at 400 V
Install Schneider Electric LC1D32F7C with the documented LC1D32F7 control circuit, contact arrangement and motor protection. Verify conductor routing, coil voltage, auxiliary contacts and the approved application before energizing.
Important Notice: Confirm the LC1D32F7C marking, wiring, motor load and control-circuit protection before commissioning.
Apter Power Schneider Electric LC1D32F7C Manuals and Guides
The first document is an Apter Power technical reference. The second is the official Schneider Electric LC1D32F7 data sheet, used as authorized for this product. Confirm the physical nameplate, current Schneider Electric documents and installed-system requirements before installation.
Motor switching
Controls three-phase motors in documented TeSys Deca applications with the authorized LC1D32F7 contactor record.
15 kW AC-3 loads
Supports motor-control duties up to the documented 15 kW at 400 V AC-3 rating.
110 V control circuits
Integrates a 110 V AC 50/60 Hz coil into compatible control-panel command circuits.
Panel protection systems
Pairs the contactor with project overload, short-circuit and emergency-stop protection requirements.
Read the current Schneider Electric documentation and control-panel instructions before use. Verify LC1D32F7C and the authorized LC1D32F7 source configuration from the physical nameplate.
1
Verify the Schneider Electric LC1D32F7C marking and authorized LC1D32F7 source configuration before installation.
2
Confirm the 110 V AC 50/60 Hz coil supply before energizing the control circuit.
3
Check three-pole main-contact wiring and the intended three-phase motor connection.
4
Verify the 32 A AC-3 current and 15 kW at 400 V motor duty against the project load.
5
Confirm overload and short-circuit protection are coordinated with the contactor installation.
6
Record auxiliary 1 NO + 1 NC assignments, isolate circuits and complete a controlled motor start before release.
Videos
News
Applications
