Product image is representative; revision or series may vary. Contact us to request a specific version.
Product Describe:
Bently Nevada 24710-080-01-00 identifies an armored 8.0 m extension cable configuration for a legacy 7200 Series 11 mm proximity transducer system. The cable is factory trimmed for electrical length and must remain matched to the installed probe and Proximitor.
Bently Nevada 24710-080-01-00 identifies an armored 8.0 m extension cable configuration for a legacy 7200 Series 11 mm proximity transducer system. The cable is factory trimmed for electrical length and must remain matched to the installed probe and Proximitor.
8.00 m factory-trimmed electrical length
Armored 95 ohm coaxial construction
Male-to-female legacy extension interface
7200 Series 11 mm system compatibility
Route 24710-080-01-00 as the matched 7200 extension cable without changing its factory-trimmed electrical length.
Important Notice: Confirm 24710-080-01-00, both connectors, the armored route and the installed 7200 system before release.
The first document presents model-specific technical and system data. The second provides a separate installation, connection, commissioning and acceptance workflow.
Legacy probe extension
Extends the approved 7200 Series 11 mm probe connection.
Turbine monitoring
Carries the matched proximity signal between probe and Proximitor.
Cable-route restoration
Preserves the documented electrical length during maintenance.
Obsolete-system support
Maintains a controlled identity for an installed legacy transducer chain.
Read the applicable Bently Nevada instructions before work. Verify Bently Nevada 24710-080-01-00 and the installed system configuration before commissioning.
1
Verify the complete 24710-080-01-00 marking.
2
Confirm the supported 24710-080-01 ordering blocks.
3
Do not cut or alter the factory-trimmed cable.
4
Inspect both connectors for keying, contamination and damage.
5
Support the armor without sharp bending or twisting.
6
Keep the route separated from interference sources.
7
Match probe plus extension length to the installed Proximitor.
8
Verify bias gap and dynamic response before release.
Technical notes
The official legacy table decodes catalog configuration 24710-080-01 as 8.00 m electrical length with armor. Preserve the user-supplied final -00 identity without assigning an unsupported meaning, and verify the complete installed transducer chain before replacement.