The 330101-02-70-10-11-05 is a Bently Nevada 3300 XL 8 mm unarmored probe with 3/8-24 UNF threads, 0.2 in unthreaded length, 7.0 in case length, 1.0 m FluidLoc cable, protected ClickLoc connector, and CSA, ATEX, and IECEx approvals option.
- 3300 XL 8 mm FluidLoc proximity probe
- 3/8-24 UNF
- None
- 0.2 in
It measures probe-to-target distance without contact and uses FluidLoc cable to impede oil migration through the lead while delivering vibration, position, Keyphasor, or speed signals through a matched extension cable and Proximitor Sensor. For dependable measurement, follow the official system-matching, target, mounting, cabling, environmental, and approval instructions.
Important Notice: FluidLoc option 11 and the 7.0 in case are official configurations. Check routing, clearances, system length, and approval markings before installation.
Apter Power 330101-02-70-10-11-05 Original Product Manual
Important Notice: This Apter Power original manual summarizes manufacturer-published technical data for the exact ordering code. Verify the physical nameplate and current manufacturer installation documents before use.
Fluid-Film-Bearing MachineryProvides non-contacting shaft vibration and position measurements on rotating machinery equipped with fluid-film bearings.
Radial Shaft VibrationMeasures dynamic shaft motion relative to the long 3/8-24 UNF mounting case mounting location.
Static Shaft PositionMeasures the static gap between the probe tip and a conductive shaft or target through the complete transducer system output.
Oil-Exposed Cable RoutesFluidLoc construction is intended to reduce oil or liquid migration through the probe cable interior.
Speed MeasurementSupports rotational-speed measurement when system length, target geometry, and monitoring-channel requirements are satisfied.
Machinery ProtectionSupplies a conditioned vibration or position signal to a compatible Bently Nevada monitoring system.
Read and follow Bently Nevada 3300 XL 8 mm Proximity Transducer System Datasheet 141194 Rev. AM and the applicable installation instructions before use. Verify the complete ordering code from the physical nameplate and match every component to the published system configuration.
1Verify that the 7.0 in case clears internal machine structures and does not create side-view interference.
2Match the 1.0 m probe to a 4.0 m or 8.0 m FluidLoc extension cable for the selected Proximitor Sensor length.
3Maintain the 25.4 mm bend radius and do not expose the unarmored lead to crushing or abrasion.
4Gap and test the complete system using the intended target material.
5Confirm the 05 approval marking and safe-use requirements from the nameplate and current drawings.
Videos
News
Applications
