The GE Fanuc IC660CBB902 is a Phase B Genius I/O bus controller with diagnostics for a Series Six programmable controller. It links the Series Six PLC to a Genius serial bus and coordinates cyclic I/O, device diagnostics and supported datagram communications.
- IC660CBB902
- Series Six Genius I/O bus controller with diagnostics
- Phase B
- Genius serial bus
Installed in a compatible Series Six rack, the controller scans Genius I/O devices, transfers input data to the PLC and sends output data from the PLC to the bus. Phase B operation also supports programmed communications and documented redundancy arrangements. It is a communications controller; the attached Genius blocks determine the physical discrete, analog or RTD signal characteristics.
Important Notice: Keep the complete IC660CBB902 marking unchanged and verify the physical nameplate, revision, companion hardware, and current manufacturer documentation before installation or replacement.
Apter Power IC660CBB902 Manuals and Guides
Important Notice: These are two separate Apter Power documents prepared from the manufacturer evidence named in each document. Confirm the physical nameplate, current manufacturer documentation, and applicable installation or system drawing before installation or replacement.
Control System Integration
Legacy Series Six automation systems with distributed Genius I/O, including process skids, utility systems, material handling and installations requiring CPU communications or supported bus redundancy.
Signal and Data Handling
Genius serial-bus I/O data, device diagnostics and supported programmed communications. Field signal voltage, current and sensor type are defined by each connected Genius I/O block.
Companion Hardware
Series Six CPU and compatible rack, Genius I/O serial bus, Genius I/O blocks, approved bus cable and terminating resistors, and a compatible Hand-held Monitor for setup and diagnostics.
Commissioning and Verification
Use IC660CBB902 only after confirming its complete nameplate, revision, configuration, connections, and every affected system function.
Read and follow the named manufacturer source and applicable installation instructions before use. Verify the exact complete ordering code from the physical nameplate.
1
Match the complete IC660CBB902 revision and Series Six CPU/software compatibility before installation.
2
Keep bus data rate, cable type, total length, termination and device addresses consistent with the approved Genius network design.
3
Do not apply field ratings from the bus controller to an I/O point; verify the individual Genius block manual.
4
Observe the applicable wiring, grounding, approval, environmental and enclosure requirements.
5
Record the complete model, revision, configuration and commissioning results before returning the system to service.
Videos
News
Applications