The 330904-00-10-50-02-05 is a Bently Nevada 3300 XL NSv non-contacting eddy-current proximity probe. Its complete code specifies M8 x 1 standard mounting, stainless-steel armor, 0 mm unthreaded length, a 100 mm overall case, an integral 5.0 m (16.4 ft) standard cable, a ClickLoc connector without protector, and the multiple-approvals option.
- M8 x 1
- Stainless steel armor with jacket
- 0 mm
- 100 mm
Connected to the matching 330980 Proximitor Sensor, the probe detects the gap to a conductive shaft or target and the sensor converts that gap into a voltage. The compact NSv system supports radial vibration and position, axial thrust position, Keyphasor phase reference, tachometer, and zero-speed measurements on machines with limited side-view, rear-view, or target clearance. For dependable operation, follow the official system-matching, mounting, wiring, environmental, and approval instructions.
Important Notice: Match the integral 5.0 m (16.4 ft) probe directly to the same-length 330980 sensor. Verify M8 x 1 engagement, target geometry, final electrical gap, cable routing, and approval evidence.
Apter Power 330904-00-10-50-02-05 Manuals and Guides
Important Notice: These are two separate Apter Power documents prepared from the official Bently Nevada source named in each document. Confirm the physical nameplate, current manufacturer documentation, and applicable installation drawing before installation or replacement.
Compact Compressors
Fits restricted probe locations on centrifugal air, refrigeration, and process-gas compressors.
Small-Shaft Radial Vibration
Measures shaft motion where standard 8 mm probe clearance is limited.
Axial Position
Tracks thrust movement against a suitable flat target.
Keyphasor Reference
Provides phase reference from a suitable notch or projection.
Tachometer Service
Supports speed measurement with correct target geometry and monitor setup.
Zero-Speed Detection
Supports low-speed or stopped-shaft indication through a compatible monitoring channel.
Read and follow the official manufacturer source and applicable installation instructions before use. Verify the exact complete ordering code from the physical nameplate.
1
Use a 5.0 m 330980 NSv Proximitor Sensor; this integral 5.0 m probe connects directly without an extension cable.
2
Limit M8 x 1 engagement to 12 mm and follow the official mounting instructions.
3
Maintain the 25.4 mm minimum cable bend radius and protect the armor, connector, and cable transition from impact or crushing.
4
Set the final gap electrically against the actual target; do not rely only on the mechanical distance.
5
Confirm the physical option-05 marking, current certificate, barriers, and installation drawing before hazardous-area use.
Videos
News
Applications
