The 330130-060-00-05 is a Bently Nevada 3300 XL 8 mm standard extension cable with a 6.0 m electrical length, standard FEP-insulated cable construction, ClickLoc connectors without factory protectors, and the CSA, ATEX, and IECEx approvals option.
- 3300 XL standard extension cable
- 6.0 m (19.7 ft)
- FEP-insulated 75 Ω triaxial cable
- None
It connects a compatible 3300 XL probe to the Proximitor Sensor, carries the eddy-current transducer signal, and completes the published system electrical length; this 6.0 m cable is used with a 3.0 m 330101 probe to form a 9.0 m 3300 XL 8 mm system. For dependable measurement, follow the official system-matching, target, mounting, cabling, environmental, and approval instructions.
Important Notice: The 6.0 m length is valid only when the probe and extension cable add to the Proximitor Sensor total length; the 3.0 m probe option is restricted to 330101.
Apter Power 330130-060-00-05 Original Product Manual
Important Notice: This Apter Power original manual summarizes manufacturer-published technical data for the exact ordering code. Verify the physical nameplate and current manufacturer installation documents before use.
Nine-Metre Transducer SystemsCombines with a 3.0 m 330101 probe to complete the published 9.0 m electrical system length.
Fluid-Film-Bearing MachineryRoutes the proximity signal between the machine-mounted probe and the Proximitor Sensor.
Radial Vibration ChannelsMaintains the matched connection used for dynamic shaft-motion measurement.
Position ChannelsCarries static or axial position signals from the probe system.
Keyphasor and SpeedSupports phase-reference and speed measurements when all components and target geometry are compatible.
Monitoring EnclosuresProvides a flexible cable route from machinery to a correctly located Proximitor Sensor enclosure.
Read and follow Bently Nevada 3300 XL 8 mm Proximity Transducer System Datasheet 141194 Rev. AM and the applicable installation instructions before use. Verify the complete ordering code from the physical nameplate and match every component to the published system configuration.
1Use only where probe length plus 6.0 m equals the selected Proximitor Sensor system length.
2For a 9.0 m system, the official 3.0 m probe option is available only on the 330101 probe family.
3Maintain the 25.4 mm minimum bend radius and protect the unarmored cable from abrasion.
4Install ClickLoc connectors finger-tight and protect exposed joints from oil or moisture as required.
5Verify the 05 approval markings and current hazardous-area installation drawing.
Videos
News
Applications
