ABB IMDSO04 is a legacy sixteen-channel digital slave output module for 24 VDC control signals in the INFI 90 and Harmony Rack installed-base evolution path. ABB's official materials verify the exact identity and describe it as a Digital Slave Output Module.
- Product type: Digital slave output module
- Channels: 16 digital outputs
- Documented output class: 24 VDC
- Function code: FC83
The module receives controller output commands and switches discrete field-control circuits for two-state equipment functions. ABB's evolution table identifies function code 83 for IMDSO04, while exact per-channel current, output topology, protection, and fail-state behavior remain HOLD because an ABB-hosted exact instruction was not located. Field circuits connect through the installed termination and cable arrangement in the Harmony Rack architecture. ABB maps IMDSO04 to SPDSO14 as an engineered replacement path; SPDSO14's higher-detail catalog ratings must not be copied backward to IMDSO04. Typical verified-use categories include commanding interposing relays, annunciation circuits, solenoids, and other 24 VDC on/off loads only after the installed load and interface hardware are checked. Migration from IMDSM05 to IMDSO04 requires output-wire polarity reversal, and ABB states that DLS is not supported in that replacement scenario.
Important Notice: Do not merge IMDSO04 with IMDSO14, SPDSO14, or any ABB service inventory form.
Apter Power IMDSO04 Manuals and Guides
Important Notice: The first link is the model-specific product-parameters PDF prepared only from the cited ABB official evidence; the second link is the Apter Power product information manual. Confirm the physical nameplate, current ABB documents, and host-system requirements before installation or replacement.
Relay command outputsCommands verified 24 VDC interposing-relay circuits in legacy control panels.
Alarm annunciationDrives approved discrete indication or annunciator interfaces under controller logic.
Solenoid and actuator commandsProvides two-state control through correctly rated project interface hardware.
Engineered output migrationSupports controlled migration assessment to SPDSO14 with termination, load, and polarity verification.
Read and follow the exact ABB documentation and host-equipment instructions before work. Verify the complete physical nameplate and system configuration.
1Verify the full IMDSO04 nameplate and revision; do not substitute IMDSO14 or SPDSO14 data.
2Confirm every field circuit is a verified 24 VDC output circuit and that the load/interface rating is documented.
3Do not publish or rely on SPDSO14 current, topology, protection, power, or temperature values as IMDSO04 values.
4Confirm the exact termination unit, cable, polarity, commons, fusing, and field supply from approved drawings.
5When replacing IMDSM05 with IMDSO04, follow ABB's output-wire polarity-reversal requirement and do not claim DLS support.
6De-energize and follow site electrical-safety procedures before field-wiring work; do not assume hot removal is safe.
7Back up FC83 configuration, output mapping, interlocks, and fail-state requirements before replacement.
8Function-test all sixteen outputs, including safe-state behavior, before returning the equipment to service.
9Keep exact current, topology, protection, lifecycle, origin, HS code, dimensions, and weight HOLD until exact ABB evidence is obtained.
Videos
News
Applications
