ABB FIO-11 is a general-purpose analog and digital I/O extension module for a compatible ABB drive; ABB's current public product ID is 68805384, while requested code 68679079 is not corroborated in the reviewed ABB sources and remains on nameplate/order-record hold.
- Module type: General-purpose analog and digital I/O extension
- Verified model: FIO-11
- Current ABB public product ID: 68805384
Installed in a documented drive option slot, it expands the drive's control interface with three analog inputs, one analog current output, and two programmable digital input/output channels so the drive application can receive extra process values and discrete states and can issue an analog command or digital outputs. Each analog input can be hardware-selected for -10 to +10 V or -20 to +20 mA signals; the analog output supplies 0 to 20 mA, while each digital channel can operate as an input or as push-pull, open-collector, or sourcing/sinking output according to the ABB manual. All I/O shares one potential area with common isolation from the drive control electronics. FIO-11 is used with an ABB drive and firmware combination whose ordering information or hardware manual explicitly lists the module, together with its detachable terminal plugs, correct shielded signal cabling, field sensors, transmitters, switches, interlocks, and receiving devices in variable-speed drive cabinets for machinery or process automation.
Important Notice: Before publishing the requested numeric code as confirmed, obtain a clear ABB nameplate or exact ABB order record showing both FIO-11 and 68679079.
Apter Power FIO-11 - Requested Code 68679079 Verification Manuals and Guides
Important Notice: The first link is the product-parameters PDF prepared only from the cited manufacturer information; the second link is the Apter Power product manual. Confirm the physical nameplate, current manufacturer documents, and host-system requirements before installation or replacement.
Extra analog feedback
Adds three voltage/current inputs for documented process values such as drive-related setpoints or feedback signals when the host drive program supports FIO-11.
Analog command output
Provides one 0-to-20-mA output for a compatible receiving device in a drive control cabinet.
Digital interlocks and statuses
Uses the two configurable 24 V channels to receive switch/interlock states or command small documented loads.
Expanded drive automation
Extends the I/O available to a compatible ABB drive in machinery and process-control installations without assigning the module unsupported stand-alone PLC functions.
Read and follow the current ABB documentation and host-equipment instructions before work. Verify the complete physical nameplate and system configuration.
1
Verify the physical ABB label and exact order record before associating requested code 68679079 with FIO-11; the current ABB public product ID is 68805384.
2
Confirm the exact host drive type, control-unit option slot, and firmware support in the drive hardware and firmware manuals before installation.
3
Only qualified electrical personnel may work on the drive. Isolate drive mains and all external control voltages, wait the discharge time stated by ABB, and verify that hazardous voltage is absent.
4
Set each analog input slide switch to the same voltage or current mode configured in the drive application before energizing the circuit.
5
Keep analog signals within -10 to +10 V or -20 to +20 mA and the digital input below the documented 30 V maximum; do not exceed the 50 mA source/sink output rating.
Videos
News
Applications
