The 330901-11-43-10-02-05 is a Bently Nevada 3300 XL NSv non-contacting eddy-current proximity probe with a 1/4-28 UNF threaded case, no armor, 1.1 in unthreaded length, 4.3 in case length, a 1.0 m standard cable, a miniature ClickLoc connector without a protector, and the multiple-approvals option.
- 3300 XL NSv Proximity Probe
- 1/4-28 UNF
- Without armor
- 1.1 in
With a correctly matched 3300 XL NSv extension cable and Proximitor Sensor, it senses the distance to a conductive target and supports radial vibration, axial or thrust position, Keyphasor reference, tachometer, and zero-speed measurements on machines where mounting clearance is limited. For dependable measurement, follow the official system-matching, target, mounting, cabling, environmental, and approval instructions.
Important Notice: The 05 suffix is an official multiple-approvals option; certification remains installation-specific and must be verified from the nameplate and current drawing.
Apter Power 330901-11-43-10-02-05 Product Manual
Important Notice: This manual is prepared and hosted by Apter Power using manufacturer-published technical data. Confirm the physical nameplate, current manufacturer documentation, and applicable certification before installation or replacement.
Tight-Clearance Compressors
Fits proximity measurement locations where a standard 8 mm probe or mounting arrangement has insufficient clearance.
Centrifugal Air Compressors
Supports shaft vibration and position measurements on compact air-compressor trains with compatible targets and mounting geometry.
Refrigeration Compressors
Provides non-contacting shaft-motion sensing in refrigeration compressor applications identified by the manufacturer.
Process Gas Compressors
Supports vibration, axial-position, and reference measurements on process-gas compressors under the published environmental limits.
Small-Shaft Radial Vibration
Measures dynamic shaft motion with the complete, correctly matched NSv transducer system.
Keyphasor and Speed
Supports phase reference, tachometer, and zero-speed applications when target geometry and monitoring input meet official guidance.
Read and follow the official 3300 XL NSv Proximity Transducer System datasheet and applicable installation instructions before use. Verify the complete ordering code from the physical nameplate and match all transducer components to the published system length.
1
Match probe length plus extension-cable length to the Proximitor Sensor total length.
2
Maintain the 25.4 mm minimum cable bend radius.
3
Do not exceed 0.375 in thread engagement or the published case torque.
4
Set the system gap near 1.0 mm using the intended target and complete connected system.
5
Confirm the multiple-approval marking and applicable installation drawing before hazardous-area use.
Videos
News
Applications
