The 330103-00-03-10-02-02 is a Bently Nevada 3300 XL 8 mm non-contacting eddy-current proximity probe with an M10 x 1 threaded case, no armor, a 1.0 m standard cable, and a miniature ClickLoc connector. With the correctly matched Proximitor Sensor, it supports static shaft-position and dynamic shaft-vibration measurement.
- M10 x 1 threaded 3300 XL 8 mm probe without armor
- 0 mm unthreaded length and 30 mm overall case length
- 1.0 m standard FEP-insulated triaxial cable
- Miniature coaxial ClickLoc connector without a connector protector
The 3300 XL 8 mm Proximity Transducer System is intended for vibration and position measurements on fluid-film-bearing machinery and can also support Keyphasor reference and speed measurements when applied according to Bently Nevada instructions. The probe and 3300 XL Proximitor Sensor form a matched system. For dependable measurement, follow the official system-matching, gap, target, mounting, cabling, environmental, and approval instructions.
Important Notice: The final 02 agency-approval code is not defined in datasheet 141194 Rev. AM. Confirm the physical nameplate and current certification before selection or installation.
Apter Power 330103-00-03-10-02-02 Product Manual
Important Notice: This manual is prepared and hosted by Apter Power using manufacturer-published technical data. Confirm the physical nameplate, current manufacturer documentation, and applicable certification before installation or replacement.
Fluid-Film-Bearing Machinery
Provides non-contacting shaft vibration and position measurements on machinery equipped with fluid-film bearings.
Radial Shaft Vibration
Measures dynamic shaft motion relative to the probe mounting location when used as a correctly matched 3300 XL 8 mm system.
Static Shaft Position
Measures the static distance between the probe tip and a conductive shaft or target through the complete transducer system output.
Keyphasor Reference
Supports phase-reference measurements when installed and applied according to the official Bently Nevada instructions.
Speed Measurement
Supports rotational-speed measurement applications when the probe, target geometry, Proximitor Sensor, and monitoring channel meet the manufacturer requirements.
Machinery Protection & Condition Monitoring
Supplies shaft-vibration or position signals to compatible Bently Nevada monitoring systems for machinery-protection and condition-monitoring applications.
Read and follow the official 3300 XL 8 mm Proximity Transducer System datasheet and applicable installation instructions before use. Match the probe and Proximitor Sensor to the same total system length and verify the complete ordering code from the physical nameplate.
1
Use a 1.0 m system-length 3300 XL Proximitor Sensor with this 1.0 m probe; do not add an extension cable unless the resulting total system length and sensor configuration are officially matched.
2
Do not bend the probe cable below the published minimum bend radius of 25.4 mm (1.0 in).
3
For radial-vibration applications, set the recommended gap near 1.27 mm (50 mils), approximately -9 Vdc, using the specified target material and official procedure.
4
Do not exceed the published 15 mm maximum M10 x 1 thread engagement, and follow the manufacturer mounting and torque instructions.
5
Do not infer hazardous-area approval from the final 02 suffix; confirm the nameplate, current certification, and applicable installation drawing before use.
Videos
News
Applications
