The 330930-065-04-BR is a Bently Nevada 3300 XL NSv extension cable with a 6.5 m length, stainless-steel armor with an FEP jacket, a connector protector, and the BR country-specific approval option supported for the 330930 family by the official approvals guide.
- 3300 XL NSv Extension Cable
- 6.5 m (21.3 ft)
- 7.0 m NSv system with a 0.5 m probe
- Flexible AISI 302 stainless steel
It carries the high-frequency probe circuit between a 0.5 m NSv proximity probe and a 7.0 m NSv Proximitor Sensor, preserving the calibrated electrical length required to condition vibration, position, Keyphasor, tachometer, or zero-speed signals. For dependable measurement, follow the official system-matching, target, mounting, cabling, environmental, and approval instructions.
Important Notice: BR is an official country-specific option for 330930 in guide 108M1756 Rev. AV; the physical nameplate and current Brazil approval remain controlling.
Apter Power 330930-065-04-BR Product Manual
Important Notice: This manual is prepared and hosted by Apter Power using manufacturer-published technical data. Confirm the physical nameplate, current manufacturer documentation, and applicable certification before installation or replacement.
Compressor Casing Cable Routes
Connects a compact NSv probe inside or near compressor casings to remotely mounted signal-conditioning electronics.
Armored Industrial Routing
Protects the transducer cable along routes exposed to mechanical contact or installation handling.
Centrifugal Air Compressors
Supports 7 m NSv vibration and position systems used on compact air-compressor machinery.
Refrigeration Compressors
Maintains the matched probe circuit between tight-clearance sensing points and the monitoring cabinet.
Process Gas Compressors
Carries NSv shaft-motion signals through an FEP-jacketed armored cable assembly.
Keyphasor and Speed Channels
Transfers the NSv probe waveform used for phase reference, tachometer, or zero-speed channels.
Read and follow the official 3300 XL NSv Proximity Transducer System datasheet and applicable installation instructions before use. Verify the complete ordering code from the physical nameplate and match all transducer components to the published system length.
1
Use only with a 0.5 m NSv probe and 7.0 m Proximitor Sensor to maintain total system length.
2
Do not bend below 25.4 mm or damage the armor termination.
3
Tighten ClickLoc connectors finger-tight until they click; do not use excessive torque.
4
Keep connector surfaces clean and install the protector as directed.
5
Confirm BR certification, product marking, barriers, and the applicable installation drawing before hazardous-area use.
Videos
News
Applications
