The 330104-01-08-05-11-05 is a Bently Nevada 3300 XL 8 mm non-contacting eddy-current probe with an M10 x 1 threaded armored case, 10 mm unthreaded length, 80 mm case length, 0.5 m FluidLoc cable, ClickLoc connector with protector, and the multiple-approvals option.
- 3300 XL 8 mm Proximity Probe
- 8.0 mm (0.31 in)
- M10 x 1
- Stainless-steel armor
Connected through a correctly matched 4.5 m extension cable to a 5.0 m 3300 XL Proximitor Sensor, it detects the distance to a conductive target and supports static shaft position, dynamic shaft vibration, Keyphasor reference, and speed measurements on fluid-film-bearing machinery. For dependable measurement, follow the official system-matching, target, mounting, cabling, environmental, and approval instructions.
Important Notice: The 05 suffix is defined as the CSA, ATEX, and IECEx option; exact certification and safe-use conditions must be confirmed from the nameplate and current documents.
Apter Power 330104-01-08-05-11-05 Product Manual
Important Notice: This manual is prepared and hosted by Apter Power using manufacturer-published technical data. Confirm the physical nameplate, current manufacturer documentation, and applicable certification before installation or replacement.
Fluid-Film-Bearing Machinery
Provides non-contacting vibration and position measurements on rotating machinery equipped with fluid-film bearings.
Radial Shaft Vibration
Measures dynamic shaft motion relative to the armored M10 probe mounting location.
Static Shaft Position
Measures the static gap to a conductive shaft or target through the complete transducer output.
Oil-Exposed Cable Routes
FluidLoc cable is intended to reduce oil or liquid migration through the cable interior.
Keyphasor Reference
Supports phase-reference measurement when target geometry and monitoring input meet official requirements.
Machinery Protection
Feeds a correctly conditioned vibration or position signal to compatible Bently Nevada monitoring systems.
Read and follow the official 3300 XL 8 mm Proximity Transducer System datasheet and applicable installation instructions before use. Verify the complete ordering code from the physical nameplate and match all transducer components to the published system length.
1
Use a 4.5 m compatible extension cable to form the required 5.0 m total system.
2
Maintain the 25.4 mm minimum bend radius and do not crush the armor or FluidLoc cable.
3
Do not exceed 15 mm M10 x 1 thread engagement; follow official torque guidance.
4
Gap the complete system near -9 Vdc using the intended target material.
5
Verify the 05 approval marking and applicable hazardous-area drawing before installation.
Videos
News
Applications
