330910-00-10-10-01-05

FAQS

• How should 330910-00-10-10-01-05 be paired with the rest of the transducer system?
  Use it with a compatible 3300 XL NSv extension cable and 3300 XL NSv Proximitor Sensor. The probe length plus extension-cable length must equal the Proximitor Sensor system length.
• What mechanical configuration does 330910-00-10-10-01-05 provide?
  It is a standard-mount metric probe with an M10 x 1 threaded case and stainless-steel armor. Its ordering code specifies 0 mm unthreaded length and 100 mm overall case length.
• What cable configuration is supplied on 330910-00-10-10-01-05?
  The probe has a 1.0 m total length with standard cable and a miniature coaxial ClickLoc connector fitted with a connector protector.
• What gap should be used when commissioning 330910-00-10-10-01-05?
  The published recommended gap for the 3300 XL NSv system is 1.0 mm (40 mils), using the applicable target material and system conditions in the datasheet.
• What measurement range applies to a system using 330910-00-10-10-01-05?
  A correctly matched 3300 XL NSv system has a published linear range of 1.5 mm (60 mils), approximately 0.25 to 1.75 mm from the target.
• What scale factor should be checked for 330910-00-10-10-01-05?
  The 3300 XL NSv system uses a nominal incremental scale factor of 7.87 V/mm (200 mV/mil). Verify the installed system, target material and calibration conditions.
• Can 330910-00-10-10-01-05 be used for phase and speed measurements?
  The 3300 XL NSv system supports radial vibration, axial position, tachometer or zero-speed measurements, and phase-reference Keyphasor signals when correctly configured.
• What installation precautions apply to 330910-00-10-10-01-05?
  Protect the probe and connector from electrostatic discharge, observe cable bend and clearance requirements, keep protected connectors non-submersed, and follow the applicable hazardous-area installation drawing.